This standard is issued under the fixed designation A /A M; the 1 This specification is under the jurisdiction of ASTM Committee A ASTM A/AM: Standard Specification for Steel, Sheet and Strip, Heavy- Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural. Find the most up-to-date version of ASTM A at Engineering

Author: JoJoran Akinobar
Country: Turkmenistan
Language: English (Spanish)
Genre: Environment
Published (Last): 3 August 2017
Pages: 97
PDF File Size: 20.52 Mb
ePub File Size: 1.92 Mb
ISBN: 531-8-37438-369-6
Downloads: 4420
Price: Free* [*Free Regsitration Required]
Uploader: Goltikora

Camber should not exceed 1 in. Within the text, the SI units are shown in brackets. For strip over 8 in.

When required, minimum coil weights are subject to negotiation. B The tolerances provided in the table are based on minimum thickness tolerance over, no tolerance under.

The ability of manufacturers to meet the maximum coil weights depends upon individual mill equipment. Over 8 to 12, incl Crown Tolerances for Speci? Combining values from the two systems may result in non-conformance with the standard.

Questions or comments about MatWeb? Depending upon the angle of the bevelled edge cut, the width of the narrow surface of the cut-edge coil may be less than the minimum ordered width.

  BOOK OF AZAZEL EA KOETTING PDF

To see MatWeb’s complete data sheet for this material including material property data, metal compositions, material suppliers, etcplease click the button below. They must not be overheated during cutting to the extent of causing decarburization.

Cut Edge and 3? However, unless the z635 specifies the applicable “M” specification designation SI unitsthe material shall be furnished to inch-pound units. Please read our License Agreement regarding materials data and our Privacy Policy. NOTE 2—The term weight is used when inch-pound units are the standard. Tolerances for the dimensions of sheet and strip coils are specified. Size Limits, Coils Only.

AK Steel ASTM A and A Hot Rolled Carbon Steel, Structural Steel (SS)

Cast or heat analysis shall be made to determine the conformance with the requirements. These coils are normally produced from rimmed, capped, or semi-killed steel.

NOTE 1—Camber is the deviation of a side edge from a straight line. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. It is informational only and not an official part of the standard; the full text of the standard itself must q635 referred to for its use and application.

  LEE SMOLIN THE TROUBLE WITH PHYSICS PDF

However, under Aa635, the preferred term is mass.

NOTE 1—Heavy-thickness edge cutting results in a bevelled edge. For nominal thickness, the tolerance is divided equally over and under.

Steel subjected to certain heating operations by the purchaser may not give chemical analysis results that properly represent its original composition. Dimensions and Tolerances 8. We also ask that you refer to MatWeb’s terms of use regarding this information.

ASTM A635 Grade 1018

Cut Edge and 1-in. NOTE 3—The industry de? Over 8 to 12, incl A Speci? Carbon Manganese to 0. The term weight is used when inch-pound units are the standard.

Within the text, the SI units are shown in brackets. Retests and Disposition of Non-Conforming Material xstm Click here to view all the property values for this datasheet as they were originally entered into MatWeb.

Approved May 1, Structural steel may be ordered when the coils are intended for conversion to plate steels.